Almost finished the rebuild of my CNC Router,
Im using MAch4 with and ESS Smooth Stepper
All 3 Axis are running fine but I need help on the configuration and placement of my limit & Home switches.
I'm using a switch at each end of the x Axis and the Y Axis and one switch at the top of travel on my Z Axis.
I may have assigned these wrongly so please advise If I need to alter them.
I'm getting errors such as 'Cant jog towards x-' etc
So I need to configure them in the ESS Plugin and Mach 4 setup.
Any help would be appreciated.
Limit Switches configuration.
Reply with Quote
