Finding odd gear rack pitch on a router table rebuild


Results 1 to 1 of 1

Thread: Finding odd gear rack pitch on a router table rebuild

  1. #1
    Member
    Join Date
    Feb 2012
    Location
    USSA
    Posts
    4
    Downloads
    0
    Uploads
    0

    Default Finding odd gear rack pitch on a router table rebuild

    Good evening I am rebuilding an Accu-cut router table and trying to figure out the gear rack pitch. Through out the internet i see "20teeth per inch" gear racks as common racks for these machines. However the rack on this Accu-cut is much larger and I can not figure out what size it is. The closest measurement that makes sense is 4mm/tooth on the rack. I can't find this type rack anywhere online which is why I'm skeptical about my measurements for the rack and pinion pitch.

    I have pictures but apparently they are too large to up load.


    Q1: anybody familiar with this rack size or racks in general?


    thank you for your time

    Similar Threads:
    Last edited by gnrl; 08-06-2019 at 09:29 AM. Reason: keeping the question about rack sizes, other topics can be dicussed in another thread


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Finding odd gear rack pitch on a router table rebuild

Finding odd gear rack pitch on a router table rebuild