Hello to you all

[Stevem109r]

New here, from Townsville North Queensland. Just starting out with my machine. Which is a C beam. Just doing some basic 2d cuts at the moment

[Stevem109r]

[wizard]

Nice looking machine!

So how did the Reindeer end up down under?

[Stevem109r]

We had a cold snap

[Stevem109r]

Cup coasters for Xmas

[he1957]

Very cool,

How did you colour fill the etchings?

Betcha our cold snaps are colder than yours :-)


Cheers and Merry Christmas from Tasmania!

[Stevem109r]

The trick is to seal the wood first spray clear acrylic is ok as you can sand it of easily if that’s not the end finish you want. Then paint in the design with water base paint wipe of the excess then seal the whole thing.

Hope the makes some sense.

Merry Christmas to you and yours

[wizard]

Sorta makes sense. The finish certainly looks good in the pictures.

The trick is to seal the wood first spray clear acrylic is ok as you can sand it of easily if that’s not the end finish you want. Then paint in the design with water base paint wipe of the excess then seal the whole thing.

Hope the makes some sense.

Merry Christmas to you and yours

[fretman_2]

Nice machine. I've looked at those...interesting design!!