Quote Originally Posted by louieatienza View Post
Well, check again that you didn't switch the juice and ground on the power input. Also you could easily fry a drive just by having the stepper output disconnect somehow while the drive was on. Lastly make sure you didn't cross up the stepper wires. You can check which two wires are pairs by disconnecting it from the drive (while it's OFF!) short two wires and see if you feel resistance when you turn the shaft. If you do that means those two wires are from the same coil. If not then then you got them mixed - should be one pair to A+ and A- and the other pair to B+ and B-.
I have checked all wiring the controller is bad and they are send a new one hopefully it works thanks for your help!