To mr. Ullbergm who was one of the starters of this thread,
You posted a picture with a figure of lines that you have cut out. You mentioned that you didn't take the time to clear out the cut.
My questions is : How do you clear out those cuts?
If you have to do some tight corners you would propably need an end-mill with very small diameter. This would cut the outline, but leaving, as you mentioned, large islands that need to be cleared out.
Would you then take an end-mill with larger diameter to clear those islands or does the software provide some moves to rerun those spots with the small diameter end-mill ?
(please keep in mind, i'm new at this)
Thanks for any answers.
Mr.Ed.