Thanks for tuning in Jon, as allways, you have allready been there and done that. You are one talented dude!Originally Posted by JFettig
This spindle is going on my mini gantry mill to replace the DC Servo spindle on that machine as it does not provide as much power as I want and the bearings are not up to the task of radial and axial thrust.
Could you post a picture of your GT2 setup? I am thinking along the same lines. A sprocket timing belt would have less power loss.
Everyone: I must point out that Jon's (JFettig) work on the larger motor conversion is the basis for the motor setup I will use to run this spindle.
Thanks Jon
Mike