- Need Help!- Shape Grabber SGCentral
-
Member
Shape Grabber SGCentral
Folks,
I just rescued a Shape Grabber 3D scanner from heading to the scrap yard when it didn't sell at an auction (I don't think anyone knew what it was). In any case, the control PC has a drive problem and among the many issues, the SGCentral software on it crashes whenever you try to start it. Does anyone have a copy I could use to rebuild the control computer and reinstall so I can see if the hardware is OK and its worth investing the money to finish bringing it back into service with support and calibration?
Thanks!
Similar Threads:
-
- Need Help!- Shape Grabber SGCentral
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules