- Removing feed-thru punch from wood die board?
-
Member
Removing feed-thru punch from wood die board?
I'd like some advice on how to remove a broken feed-thru punch from a wood die board. The punches are only 1/16" thick so there's not much steel to press against when pressing it out. I'm new to this and wanted to get advice on what the standard procedure is before I try pressing them out with some sockets.
Similar Threads:
-
-
Member
Re: Removing feed-thru punch from wood die board?
Need photo - it does not appear.
Cheers
Roger
-
Member
-
Member
Re: Removing feed-thru punch from wood die board?
Um ...
What's not visible is how far it is sunk into the timber. That matters.
Frankly, just looking at it, I would GUESS that brute force and a hammer might be how I would try. Sorry about that.
Unless of course you can fit a tight mandrel inside it and then apply a bit of torque?
Cheers
Roger
- Removing feed-thru punch from wood die board?
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules