Hello to all and hoping you can help me. I have bought a DB6560 thre axis breakout board and did all the steps possible but i cannoot manage to make anything move.
pins and ports limit switches... all done. diagnostic screen all works fine but the board its always with XPUL on and the other two off it does not matter what i do. I had another computer connected before with windows10 and now I have Windows7 64 bits and installed an XP mode and still nothing. i have a 12 volt 10 amp power suply.... well... i thought it was broken and the seller sent me another one.... Surprise!! the same once again. Now i have two boards that only show XPUL and cannot manage to make them work.


does anybody has an idea on what can be happening?
could it be that both boards have the same failure?

any help is welcome and in advance many thanks!!!