Hi everybody i'm new member and i would like to receive some help, first of all I need to comunicate a deckel maho dmu 50 t with a computer but i don't know if a need a special software or something. I'll appreciate if somebody could explain me the process. Thanks everybody
Hello Steve i'd really appreciate if you can help me...... the operating system we have is the Heidenhain one, i'm not sure neither the wire's configuration nor the hole process for doing so ja thanks a lot
Hi Gunz,
if i'm understanding you correctly you want to connect your machine to a pc! and you have Heidenhain control is that correct. Ok if this is correct then you need to go to the Heidenhain website and download TNCremo which you install on your PC then it will allow you to upload and download.
I hope this a help to you, good luck
Steve
Thanks a lot Steve I have already downloaded the software and I hope to have some free time this week for checking the connection. One last thing ...... I have been looking for an electronic manual of a Deckel DC 30 machine but I haven't gotten it ..... Do you know if there is one?
We have a machine name is DECKEL MAHO DMC 63V
TNC 426/430
HEIDENHAIN
NC: SOFTWARE
280475 16
The problem is that our machine hard disk is dead and not working due to media card problem also our backup is crash and not repairable. We need software in above mentioned machine so that we can buy other hard drive and install it so that our machine will work smoothly.
Hi everybody i'm new member and i would like to receive some help, first of all I need to comunicate a deckel maho dmu 50 t with a computer but i don't know if a need a special software or something. I'll appreciate if somebody could explain me the process. Thanks everybody
Hello
Can you send me the document of the dmu 50t
Thanks