I could solve this problem, replace the batery of 6v, i put all the constant, then this almost work.
in test obtain alarm of Drive mod3, Input Module1, CentPro. , this look like electronics error card.
Renato
Hi good day i am checking cnc mill MH500C with control CNC 432, i obtain the errors M01 and I01,
If 19RSS1 = 0 , error M01 appears (checksum fault MC memory RAM)
if 19RSS1 = 1 , screen constant appears direct, and error I01 show it (Interface has no voltage supply).
the battery has 12.5v, and pcb CentProdMod was changed (same model of pcb for different memorys series), before a chess screen appeared.
I intend change the constant but no change, Are these some suggestions?,
should i change the battery, o how change the parameters?
regards
Renato Masias
Similar Threads:
I could solve this problem, replace the batery of 6v, i put all the constant, then this almost work.
in test obtain alarm of Drive mod3, Input Module1, CentPro. , this look like electronics error card.
Renato
dear friend,
I have M01 problem too ...at MH500C after accu change….HOW DID YOU SOLVE THE PROBLEM ???
Can you tell me
Thanks
Janos
Replace the CENT_PROCMOD put parameters again and this started working.