Hello,

We try to start up a 2nd hand Maho 1200S we bought and after some small issues we tryed to
move to reference point of the 3 axis. for some reason the Y axis goes to the end completly then goes back the whole distance.
so he doesnt find his refence.

i dont know if this is a parameter lost issue of problems reading out the liniar philips position.
or lost parameter.

so we tryed to edit parameters but for some reason i cannot change any parameter.

i followed the steps described in the manual but that doesnt help.

also changing parameter 80 from "0" to "1" isnt possible
i tryed changing with e-stop, turning the keys in back and operator panel, change par 80, cleaning lineair measure system, ....

nothing seems to help for this.

if someone know any advice? or explain what i do wrong to adjust parameters?

thanks a lot!

Similar Threads: