I have recently purchased anothe Maho. This time a 800E.
I currently have 2 problems.
The Y Axis will not move during the refrence point serch routine.
It will move away from the current position when the other axes have reached the ref point.
The Y axis will jog & move under program but not move to ref point.
Any one else experienced this?
Second fault is intermittant but in Program after spindle start and at feed start i get an alarm
"I65 N<N-Min signal during feed motion"
I did not receive the electrical drawings with the machine, so I am using my older MH600E drawings.
Paul Deady

Similar Threads: