Transfer programs from laptop to Daewoo Lynx 200L

[darrellx]

We have a Lynx 200 L and would like to transfer programs from a laptop to the machine. We have always programmed at the machine and nobody in the shop has experience transferring this data. Can anybody help us with a step by step guide through the process.

Thanks in advance for any help.

Darrell

Similar Threads:

• Can't remove draw tube Daewoo Lynx 200L
• Need Help!- lynx 200l operators manual
• Need Help!- Lynx 200L Programming Question
• Need Help!- lynx 200l lathe
• What programs do you use to transfer from laptop to lathe. Mazatrol--->ISO

[jimmyjolly]

You need to make your own cable to start with. If i]the machine has a RS232 connector then it's relatively simple, buy some RS232 and DB9 connectors because it's your first time I imagine. Also get a DB9 to USB lead and then start soldering. You will need a DNC program to handle the data transfer, there are a few free options. Figure out your data transfer parameters, baud rate, handshake, parity etc and bingo!. Yeah it is fun to learn, I learned the hard way. Plenty of info online though, good luck!

[darrellx]

You need to make your own cable to start with. If i]the machine has a RS232 connector then it's relatively simple, buy some RS232 and DB9 connectors because it's your first time I imagine. Also get a DB9 to USB lead and then start soldering. You will need a DNC program to handle the data transfer, there are a few free options. Figure out your data transfer parameters, baud rate, handshake, parity etc and bingo!. Yeah it is fun to learn, I learned the hard way. Plenty of info online though, good luck!

Thanks for the info Jimmy. Will give it a whirl.

[Heavy_Metal]

Hi darrellx,

If your Lynx has an Ethernet connector you could use the Fanuc - [ Program Transfer Tool ], it's a very cheap ( around 25 dollar ) software that transfer programs Up and Down to your PC - CNC.
There's a video on the Fanuc Europe YouTube channel: Transfer programs with the Program Transfer Tool.
Probably you need a [ CAT-Crossover cable ] for a direct connection between PC and CNC, not the normal CAT-cable via a router.

[darrellx]

Hey Heavy Metal:

Thank you for your reply. We will give it a whirl.

Darrell

[darrellx]

Hey Jimmy:

Thank you for your reply. Will give it a whirl.

Darrell

[lshingleton]

What Labtop do you have ?
Does it have 9 pin com ports or only USB ?
Most Fanucs have a 25/ pin output port and you can get a 25 pin to 9 pin NULL modem cable is the right term
If you dont get a 25 to 9 pin and then a 9 pin to USB that can be bought online no issue with at least one piece being NULL modem
Next commnication software and CIMCO is by far the best for this and its done it for over 25 yrs now and has a great Back plot and stuff for programs
Check on the setting screen what channel you are on and then check first 1000 parameter area for the settings for each channel
Good luck

[Green Button]

Software for example:
https://cadem.com/free-dnc-software/
Cable:
The GE Fanuc CNC controls Serial Cable Connection