Problem Can't indicate Tool holders on daewoo lathe

Results 1 to 3 of 3

Thread: Can't indicate Tool holders on daewoo lathe

  1. #1
    Member positiverake's Avatar
    Join Date
    Sep 2005
    Location
    United States
    Posts
    255
    Downloads
    0
    Uploads
    0

    Default Can't indicate Tool holders on daewoo lathe

    This is a 1998 deawoo puma 200 lathe, Had to remove the alignment button on the turret so I could indicate the tool Holders(blocks) in, I guess the machine had been crashed hard but had been fixed, I indicated the turret face, turn tool pocket, and side, the worse i seen was .0015 is that enough to have to pull the alignment buttons to get in line? thanks for any help

    Similar Threads:


  2. #2
    Member Algirdas's Avatar
    Join Date
    Mar 2009
    Location
    United Arab Emirates
    Posts
    1663
    Downloads
    0
    Uploads
    0

    Default Re: Can't indicate Tool holders on daewoo lathe

    Tolerable if it is below the spindle axis, unacceptable if above.
    "Above" and "below" in regards of spindle rotation direction.



  3. #3
    Member positiverake's Avatar
    Join Date
    Sep 2005
    Location
    United States
    Posts
    255
    Downloads
    0
    Uploads
    0

    Default Re: Can't indicate Tool holders on daewoo lathe

    Interesting, thanks for the reply



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Can't indicate Tool holders on daewoo lathe

Can't indicate Tool holders on daewoo lathe

Can't indicate Tool holders on daewoo lathe