Tool Setter Calibration - Lynx 2100 LSYB w/ Oi-TF Plus Control

Results 1 to 3 of 3

Thread: Tool Setter Calibration - Lynx 2100 LSYB w/ Oi-TF Plus Control

  1. #1
    Member
    Join Date
    May 2015
    Location
    USA
    Posts
    31
    Downloads
    0
    Uploads
    0

    Default Tool Setter Calibration - Lynx 2100 LSYB w/ Oi-TF Plus Control

    I have a new 2020 Lynx 2100 LSYB that has the new Oi-TF Plus control.

    Does anyone have instructions on how to calibrate the tool setter? I would call Ellison, but it is the day before thanksgiving and no one is answering the phone.

    There is a ten year old thread on this subject that talks about what numbers go in which parameters, but I am not confident those parameter addresses are the same for this new control.

    Thank You!

    Similar Threads:


  2. #2
    Member dhardt's Avatar
    Join Date
    Feb 2013
    Location
    United States
    Posts
    722
    Downloads
    0
    Uploads
    0

    Default Re: Tool Setter Calibration - Lynx 2100 LSYB w/ Oi-TF Plus Control

    I just called and they picked up on 2 rings...

    Unless Fanuc has changed their parameter, or the write-up is not for a Fanuc, it will work.

    Your instruction Manual that came with the machine has replacement process, as well.

    The attached is the Installation Manual for a Lynx 220. The process is on page 28

    Attached Thumbnails Attached Thumbnails Tool Setter Calibration - Lynx 2100 LSYB w/ Oi-TF Plus Control-lynx220_l220mise951-pdf  
    Doosan Service Technician
    darryl.hardt@doosanmt.com O:973-618-2461 M:973-803-9479


  3. #3
    Member
    Join Date
    May 2015
    Location
    USA
    Posts
    31
    Downloads
    0
    Uploads
    0

    Default Re: Tool Setter Calibration - Lynx 2100 LSYB w/ Oi-TF Plus Control

    Thank you very much for the reply. About 30 minutes after I made the post I made another call, and they did answer. They put in a case number for someone to get back with me. I might have called too early since I called right at 8:30am local. I looked in the instruction manual, but I did not see it. I will look again though. I really appreciate your help.

    Thank You!
    Darryl



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Tool Setter Calibration - Lynx 2100 LSYB w/ Oi-TF Plus Control

Tool Setter Calibration - Lynx 2100 LSYB w/ Oi-TF Plus Control

Tool Setter Calibration - Lynx 2100 LSYB w/ Oi-TF Plus Control