Dear Sir,

I am using Puma 2600 SY machine

I am facing 2 different type of problem in this machine kindly see below for details

Problem 1

G40 ,G41, Command does not function properly,
Found in spline milling operation cutter compensation is taking 2times of radius mention in the geometry offset.

Problem 2

Slot milling C1 & C2 command execution malfunction
found C1 & C2 Axis commands are using simulations the problem was observed,( zero position not correct)
after continuous analysis its confirmed by giving end of block (eob) before and after C command the position zero come correctly.


Similar Threads: