Need Help! Doosan Lynx 220L lathe chuck issue

Results 1 to 3 of 3

Thread: Doosan Lynx 220L lathe chuck issue

  1. #1
    Member Tomg1353's Avatar
    Join Date
    Nov 2019
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Doosan Lynx 220L lathe chuck issue

    Hi everyone,

    I'm getting a #2060 'CHUCK UNCLAMP STATUS' warning. The chuck opens and closes fine using the foot pedal but whether I try to start the spindle on manual or simply run the program this message appears.

    There was a similar question asked already but it seemed to be related to the actual opening/closing of the chuck...

    It's not a door interlock issue and I'm not trying to use a bar feeder. The program has been used recently on this machine so I dont think it could be a coding problem either.

    Any ideas much appreciated, thanks!

    Tom

    Similar Threads:


  2. #2
    Member dhardt's Avatar
    Join Date
    Feb 2013
    Location
    United States
    Posts
    604
    Downloads
    0
    Uploads
    0

    Default

    If you have proximity switches on the back of your actuator then it is measuring over stroke and Chuck open. Either set the proximity switches correctly, or Chuck up on a part, or turn them off to bypass them.

    Doosan Service Technician
    darryl.hardt@doosanmt.com O:973-618-2461 M:973-803-9479


  3. #3
    Member
    Join Date
    Sep 2007
    Location
    the netherlands
    Posts
    51
    Downloads
    4
    Uploads
    0

    Default Re: Doosan Lynx 220L lathe chuck issue

    hi ,

    or turn the key for inside and outside clamping


    greeting bertus



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Doosan Lynx 220L lathe chuck issue

Doosan Lynx 220L lathe chuck issue

Doosan Lynx 220L lathe chuck issue