It used to be normal for Fanuc to use % mark at the start and end of the PGM, they were originally for turning ON/OFF the tape reader or tape punch.
Al.
Hi,
We just replace our old Daewoo lathe with brand new Doosan, Fanuc i- series.
Some problems with RS232 data transfer: when program is transferred from nc to computer there is some strange marks at start of program or two % mark.
We might have some parameter wrong because old machine worked just fine. Here is example:
%%
O0003
M01
M05
M00
M30
%
Any idea what could be wrong in parameters?
EDIT: Between %% marks could be some special mark, for some reason i could not copypaste them
Thanks,
Similar Threads:
It used to be normal for Fanuc to use % mark at the start and end of the PGM, they were originally for turning ON/OFF the tape reader or tape punch.
Al.
CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Thanks, this pdf is great