2067 alarm help needed

[rgrow1]

We have a Daewoo 300LM that we are getting this alarm on intermittently. We changed out the turret confirmation prox switch but it didn't go away. We power down and reset, it will run for days between alarms and will throw this alarm in the middle of a cut. Any help would be greatly appreciated.

Similar Threads:

• Mitsubishi MR-J2s-A Help needed - alarm prob
• TM1,alarm 104 help needed
• Need Help!- 2067 TOOL SWITCH ALARM
• cnc alarm help needed

[DouglasR]

What does the text of the alarm say? What control on the machine?

[rgrow1]

18 I control "The tool and rev. spindle condition alarm. Check confirmation switch in tool post unit"

[RobM90]

What is the address of this alarm in PMC ladder? If you share me a copy of ladder I could help you...

[DouglasR]

I'm not entirely sure. I'm going to ask service.

[dhardt]

See attached document for a similar machine.

[jmfl4567]

18 I control "The tool and rev. spindle condition alarm. Check confirmation switch in tool post unit"

did you ever get this resolved?

[rgrow1]

We did get it resolved but it has been so long that I don't recall what the fix was.