Bad crash: Tool won't release, flashing release button

[CrashTestDummy3]

Not my handy work, but the Doosan Vertical Mill rapid traversed in X while the large slot mill wasn't clear. It dragged a vice about 10 inches. Now the tool release button flashes and the tool won't release. Visible run out on the tool. What's my next move here? How do I manually release the tool without damaging the drawbar?

Similar Threads:

• Using the Manual Tool Release button - Bridgeport XR1000 with Fanuc 18i-MB
• HSD SPINDLE MANUAL TOOL RELEASE BUTTON LIGHT IS.OFF
• Control Panel Tool Release Button
• Tool release problem after crash
• Tool Release Button,

[mbservice]

Complete strip down

[dhardt]

I have been away, but I'm back, now.

If this is still an issue, please call me at Doosan Machine Tools.

My contact info is in the footer of my posts.