I have a 3x4' homemade CNC, using two ball screws on the Y axis, acme threaded X and Z axis, and linear rails and trucks on all axis.
Using Gecko 251X drivers, Mach3 and Vectric VcarvePro 8.5.
Has anyone used the below Controller cards sold by L-STAR MOTOR from Amazon. I'm considering clanging my Controller boards to a more modern board at an attrive price.
It is a 5 Axix Mach3 Stepper motor comtroller board, breakout board interface fot CNC
Router, engraving, milling machine.
Thanks
Mr Chips
Similar Threads:
Thanks,
That’s correct, one is enough.
I was hoping to find someone that has used this board, they have good reviews on Amazon.
But at $25 it’s nit a bank buster. I’ll give it a couple of days before I order one.
Thanks
Did you have any luck out of yours?
I got this several weeks back and finished up my electronics this week. This damn board has ran me wild. 3 computers later Win7 32bit and XP 32bit. All pc's output correct voltage at port and cable end but once plugged into this BOB I just get 4.10v no matter the step direction (hi/low) so the prob is with this board.
I order another with the same features but totally different brand etc on Amazon.
https://www.amazon.com/Keenso-Controller-Interface-Engraving-Breakout/dp/B07PSJF5HN/ref=mp_s_a_1_1?keywords=keenso+breakout+board&qid= 1565222869&s=gateway&sr=8-1