Reply with QuoteProbing does not work properly with most of the chinese Mach3 controller boards.
Make sure the probing macro you are using does not use the GetVAR() command, as that's often where they fail.
CNC USB MACH3 100Khz Breakout Board problem
CNC USB MACH3 100Khz Breakout Board problem with auto tool probe .not work with the plugin( RnR MOTION plugin).I would ask for instructions on this board??thanks
Similar Threads:
- Need Help!- Mach3 Breakout Board 5 Axes PWM to VFD output problem...
- USB BREAKOUT BOARD FOR MACH3
- Just IN- CNC Breakout Board, CM-106, Mach3
- New Machine Build- breakout board for mach3
- Need Help!- Am i limited to 100kHz (pps) when using Mach3?
Re: CNC USB MACH3 100Khz Breakout Board problem
Probing does not work properly with most of the chinese Mach3 controller boards.
Make sure the probing macro you are using does not use the GetVAR() command, as that's often where they fail.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Re: CNC USB MACH3 100Khz Breakout Board problem
in the Diagnostic window in mach 3 digitize bright continuously picture scheme of connection...
Re: CNC USB MACH3 100Khz Breakout Board problem
Try to invert active state of probe signal in settings.
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.
Re: CNC USB MACH3 100Khz Breakout Board problem
this board definitely has a problemOriginally Posted by ZASto
Re: CNC USB MACH3 100Khz Breakout Board problem
What Jerry wrote.
Cheers
Roger
