Reply with QuoteYes. Throw it away and get a Mesa card, as your NVEM card will only work with Mach3.
NVEM 200KHz Ethernet Mach3 Card
Hi all
I have NVEM 200KHz Ethernet Mach3 Card and I want to use LinuxCNC, any one could help in this?
Similar Threads:
Re: NVEM 200KHz Ethernet Mach3 Card
Yes. Throw it away and get a Mesa card, as your NVEM card will only work with Mach3.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
I can't even get it to work with Mach3
After 8 days I have nearly got my NEVM working, re installed a clean MAch3 setup, rewired my machine to suit pnp not npn inputs and a whole lot of other stuff about 100hrs so far, It works BUT NOT Reliably, NEVM looses ethernet comms regurlarly, (been through PC and adaptor power settings and every other setting) My main problem at this time is the calibration. It changes - Long moves are perpect, 0 - 30 mm randomly loose or gain up to 3 MM way too much.
Just about had enough of the nvem ad about to throw it in the bit - Chineese DHgate seller very unhelpful and rude
I wish I had done some more research about these NVEM units I would not buy one again - Has anybody had any success in gettin one to run on Mach3.
Steve
