- A 2100 wont boot
-
Member
A 2100 wont boot
Have a lathe with a A2100 controller. It sat for several years without being used. It would be hard to boot up sometimes having to be turned on/off several times. We it did boot up it showed a checksum error which told me the WS battery was dead. I changed the WS battery and now it wont boot up and just gives one beep. I look at the error leds on the board we got a green power one so thats good and ive checked the 5 and 12 volt supplies. Initially there are two red error leds on WS fail and RT fail after a minute the RT fail goes out. Ive reseated the sim just in case and that didnt do anything.
Anys ideas of what to try next would be appreciated
Thanks
Geoff
Similar Threads:
-
- A 2100 wont boot
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules