I sent you a PM.
I might be looking at putting a new control system on a lathe I have.
Any one have any suggestions on a good control?
I have several centroids. Good control, lacking on conversational programming and speed.
I know the Mach 3,4 stuff is junk. I need a pro level system.
Fanuc & Siemens are pricey and have zero support.
Similar Threads:
- Need Help!- a good cnc router controller board!!
- New Machine Build- CNC bport clone, dead controller- good servos
- Need Help!- Is this a good quality lathe and controller?
- Need a Good CNC Lathe Book
- this lathe good to cnc?
I sent you a PM.
Jim Dawson
Sandy, Oregon, USA
Depends on what exactly you need to control. What safety system you want to implement? What are drives: spindle; X axis, Z axis. Is there any gearbox? What is hydraulic system? Parts catcher, bar pusher? What is turret drive and many other factors. I would start to see the encoders first and desice if I leave them as is or I will upgrade. Motor drives - the same story. Is it better to install new ones or leave present.
Evaluate availability of new hardware components. Then you can figure out what the control specification will be - how many analog signals, what buses, how many digital inputs / outputs.
I would say the Linuc CNC is quite flexible if you are not afraid to dig deep into operating system.
Do any retrofits have good conversational programming?