UPGRADE OF CNC SYSTEM TOSNUC TO FANUC

[vblraj279]

GOOD DAY FOLKS,

JUST SOME CLARIFIACTIONS NEEDED.
We want to UPGRADE TOSNU777 CONTROLS TO FANUC SYSYEM NEW VARIANTS.
IS IT POSSIBLE ? BUT THE AXES DRIVES SERVO AMPLIFIERS, MOTORS AND SPINDLE DRIVES WE WANT TO KEEP TOSHIBA ONLY. SPINDLE DRIVE IS YASKAWA.
CAN ANY EXPERT CAN GIVE FEED BACK ON THIS?

[mluqman]

Hi, I have same issue, want to retrofit our toshiba bm 80e but the servodrive, motor want to keep. You start to upgrade or not?. Please share it. If you have schematic diagram of servodrive I think you could easyly to use other brand controller, I already searching the manual book of the servodrive but still not yet find. If you have, maybe you could share to me