Reply with QuoteAny of the CNC Drive ethernet controllers, or an ethernet Smoothstepper.
If you don't already have a Mach3 license, then I'd go with UCCNC and a CNC Drive controller instead of Mach3.
Motion Controller
I need a motion controller for my cnc router. I am going with the ethernet controller UC300ETH-5LPT from CNCdrive. Is this the right card to use with Mach3?
Similar Threads:
Re: Motion Controller
Any of the CNC Drive ethernet controllers, or an ethernet Smoothstepper.
If you don't already have a Mach3 license, then I'd go with UCCNC and a CNC Drive controller instead of Mach3.
Gerry
UCCNC 2017 Screenset
[URL]http://www.thecncwoodworker.com/2017.html[/URL]
Mach3 2010 Screenset
[URL]http://www.thecncwoodworker.com/2010.html[/URL]
JointCAM - CNC Dovetails & Box Joints
[URL]http://www.g-forcecnc.com/jointcam.html[/URL]
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Re: Motion Controller
Hi,
all development on Mach3 ceased six years ago. I use and recommend Mach4 and Ethernet SmoothStepper.
Craig
