Need Help! Multicam SF Model w/ RPD-24 Controller, overwrote program


Results 1 to 2 of 2

Thread: Multicam SF Model w/ RPD-24 Controller, overwrote program

  1. #1
    Member jimmycissell's Avatar
    Join Date
    Aug 2020
    Posts
    6
    Downloads
    0
    Uploads
    0

    Default Multicam SF Model w/ RPD-24 Controller, overwrote program

    New to Multicam equipment, picked up an SF 4x8 table that had the original controller upgraded to the RPD-24 controller (pic attached) w/ pendant. I was exploring in MotionMechanic and inadvertently overwrote the firmware (dumbest thing I've done all week). I am in desperate need of a program file I can upload to it and checking on parameters. Right now it is dead in the water. Anyone out there that can assist? I'd rather pay someone on here a reasonable amount of $$ for help then have to contact Multicam. Thank you much!

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Multicam SF Model w/ RPD-24 Controller, overwrote program-20200821_134400-jpg   Multicam SF Model w/ RPD-24 Controller, overwrote program-20200821_134455-jpg   Multicam SF Model w/ RPD-24 Controller, overwrote program-20200821_134406-jpg  


  2. #2
    Member jimmycissell's Avatar
    Join Date
    Aug 2020
    Posts
    6
    Downloads
    0
    Uploads
    0

    Default Re: Multicam SF Model w/ RPD-24 Controller, overwrote program

    Here is a pic of where I sent a standard G-code file to. I assume it overwrote the controller program? Maybe just the parameters? Never used MotionMechanic, any help would be greatly appreciated.

    Attached Thumbnails Attached Thumbnails Multicam SF Model w/ RPD-24 Controller, overwrote program-motionmechanic-jpg  


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Multicam SF Model w/ RPD-24 Controller, overwrote program

Multicam SF Model w/ RPD-24 Controller, overwrote program

Multicam SF Model w/ RPD-24 Controller, overwrote program