RZNC 501 controller issues


Results 1 to 2 of 2

Thread: RZNC 501 controller issues

  1. #1
    Member
    Join Date
    Dec 2006
    Location
    Singapore
    Posts
    114
    Downloads
    0
    Uploads
    0

    Default RZNC 501 controller issues

    Hi all,

    been using the RZNC 501 controllers for 3 -4 years.

    Every time i start the new cutting process, the system will automatically goes to SPD GRAD 7, even though during the processing menu, I set it to SPD GRAD 1, it will still runs at SPD GRAD 7 during the cutting process.


    Another question i have: I am using ArtCam. But i cannot seems to set the speed of the milling process using the RZNC controller.
    Example i set 5000rpm on my ARTCAM, but my RZNC 501 controller only seems to runs at the speed set on the RZNC controller. I can only manually set the speed using the RZNC controller during the milling process.

    Thanks, hope you guys can help me in these issues.

    Ivan

    Similar Threads:


  2. #2
    Member ZASto's Avatar
    Join Date
    Apr 2005
    Location
    Vanuatu
    Posts
    160
    Downloads
    1
    Uploads
    0

    Default Re: RZNC 501 controller issues

    RZNC does not "understand" S parameter in G-Code, it ignores it.
    SPD GradeX is an combination of output levels on 2 pins that are connected to your VFD inputs, and speeds are programmed in VFD.
    So, there is no way to control speed via G-Code, unfortunately.

    Make no mistake between my personality and my attitude.
    My personality is who I am. My attitude depends on who you are.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

RZNC 501 controller issues

RZNC 501 controller issues

RZNC 501 controller issues