ProtoTrak MX2 convert to Mach3 or 4

[dmh13433]

Hi
Is there anyone out there that has pulled the control unit off a ProtoTrack and built a better system?
I just called Southwestern industries and they have a new controller called the KMX that is a replacement to the old units like mine the MX2
They gave me a dealer to call and talk about buying one. They want 6 to 10 thousand$$
Not going to happen, I'll just have to keep using this old MX2

Couple questions....
1. Anyone have a place I can call to source drivers for these servo motors?
2. Is there a market for this old controller? It works fine, I just want an updated system thats better?
3. Has anyone ever done this before I could talk to?

Thank You

Similar Threads:

• Build Thread- I want to convert my R2E3 to Mach3
• Convert a PlasmaCAM 98-Z to Mach3?
• I will pay for someone to convert STL to Gcode (mach3)
• convert to DSPMC/IP & mach3
• WANTED!! GibbsCAM post for Centroid M-15, ProtoTRAK LX3 and ProtoTRAK VL controls?

[RandallJ]

so what did you do?