Anilam 3200MK software Maybe?

[bertcnc]

Hi, everyone.

The hard drive died on my 2 axis mill with a 3200MK control. The original software version 3.12A is not recoverable.
I installed another HDD, with software ver.3.62 from a 3300 control.I set the configuration for 2 cnc axis and the z as DRO.
Everything works but the axis are unstable / jerking. The servos, motors and filter parameters ar all correct. The DAC signal voltage from the DSP is pulsing up or down randomly.
I think the software is the problem, not compatible with DSP.
QUESTION... Can anyone please help with a copy of software for a 3200 control or offer any advice?

Thanks in advance

Similar Threads:

• Chevalier Falcon with 2 axis Anilam 3200MK
• anilam offline software
• Anilam 1100m software
• Anilam 1400 software

[ripperj]

You may just have to tune the servos, the manuals are available online and have a section on tuning


Sent from my iPhone using Tapatalk Pro

[bertcnc]

Thanks for the input.
In case anyone is interested the problem was the digital to analog chip on the DSP board.