- Need Help!- NEWKER 1000TCa Chinese control panel
-
Registered
NEWKER 1000TCa Chinese control panel
Has anyone purchased a Chinese (Newker) 1000TDa control panel as I'm waiting on delivery of one.
After a lot of deciphering of their manual I realised that I may require "Multiturn absolute encoders" for both axis.
I am converting an as new Colchester Colt lathe with old Anilam control which has died.
I was hoping to use the original incremental encoders but now I'm not sure if it will run with them.
Need help fast .....
Similar Threads:
-
-
Member
Re: NEWKER 1000TCa Chinese control panel
Hi
I have the exact same lathe and the Newker 1000 too
I’m putting 320x geckos in it with AMT encoders for Z and X
But I’m not sure how to setup the spindle with encoder
Did you get your machine going good
Sent from my iPhone using Tapatalk
- Need Help!- NEWKER 1000TCa Chinese control panel
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules