I purchased one to control my dual drive plasma table (needing a slave axis).
I've only been testing it on the bench just to get a feel for it before I swap it in.
It's a bit rough out of the box (programming-wise). I had the update sent to me to specifically run a plasma system and there wasn't much improvement.
I'm emailing the company to resolve the few issues I've encountered and hopefully provide some positive feedback. Doesn't help that there's a huge time difference between AUS and the US, lol.
I think the system shipped a little early before making them run-ready. it does show some promise once the bugs get resolved.
The instructions do show that they connect to Clearpaths. I do have a Clearpath driven 3 axis router ( ) and those motors connected to the signal outputs like any other stepper system I messed with so I don't think there will be any issues with that. Not sure if the Masso is configured for the collision detection interrupt from the Clearpath since I don't have the mill/router software.