DX-32 Problem

[tharry]

I am running a Bridgeport VMC 1000 Mill controlled by DX-32. When I program a tool change, the spindle turns off like it is supposed to do, but I get a message that says "Spindle not up to speed in time" Then the drives shut off and I have to restart everything. What do I need to do to keep the error message from coming up and shutting everything down??

Similar Threads:

• Tube problem or powersupply problem? Help you to check out
• daewoo puma 12lb tape format problem/parameter problem
• Surface finish problem - Could you please help me overcome this problem?
• machine problem or software problem?

[KidKhaos]

Did you ever figure this problem out? My machine is doing the exact same thing.

[machinehop5]

...Backup all MTB param's write them down ASAP before something else fails during troubleshooting anything would be my advice to start> then ...power supply voltages would be the 1st to suspect to do age.

Merry Xmas