We are running a Burny 3 with Replicator. Recently our computer attached to the Burny needed replaced. The system just died and isn't able to boot.
Previous system was running SmartCAM and Burny file server on a 32 bit computer to communicate with the table via serial cable.
The system was replaced with a 64 bit computer running Turbonest software and Basic DNC (supplied by Hypertherm). The Burny file server is only good on 32 bit computers.
I'm trying to use the Basic DNC in it's place and haven't had any luck so far.
I have approximately 200 feet of cable between my computer and Burny 3. I also have a modem at the computer and also one in the Burny.

Can someone please give me a step by step over view how to get files from the computer to the Burny?

Your help is greatly appreciated

Similar Threads: