- Need Help!- laser problem
-
Registered
laser problem
Dear all.
Most of the work is fine, but when you process the patterned pattern, the part that is pushed in the y-axis occurs
Also, drawings created with integers are not problematic, and only drawings created with a decimal point cause problems
ex) 2mm circle pitch 4mm x 4mm 40x40 array (ok)
1.85mm circle pitch 2.9mm x 2.9mm 40x40 array(fail)
If you have any problems with me, please reply.
thanks regard~
Similar Threads:
Last edited by zapper76; 11-20-2018 at 07:45 AM.
-
- Need Help!- laser problem
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules