Unimatic without a tool setter

[marbles]

My cousin donated me a Unimatic EduCAM 10 recently, which was nice. Similar to an Isel I suspect.

I’d like to add a tool touch off and possibly and edge finder too. The unit has an r232 serial port on the interior of the case, which I bet is for a tool touch off or similar. Anyone any experience with adding one of these? No idea if this is NO or NC. A wiring diagram would be useful if anyone has one.

Thanks

Similar Threads:

• Build Thread- Galaand/Kay software for Isel/Unimatic
• Need Help!- Tool Setter Macro for M-V60C and Metrol Setter
• Programming a tool setter to check tool height
• Need Help!- Tool setter macro for M-V60C and Metrol setter