- Need Help!- Changed NCStudio from 5.4.48 to 5.5.60 and now axis moves in the opposite direction
-
Member
Changed NCStudio from 5.4.48 to 5.5.60 and now axis moves in the opposite direction
Hello
I am posting here on behalf of my father who owns a CNC Victor VR1212 which ran with its own controller card on the PC and NCStudio 5.4.48, he bought a few years a new card so he could use the WHB-02 controller with NCStudio 5.5.60 but it remained shelved until now.
We managed to install everything without any issues but now the X and Y axis moves in opposite directions.
I already googled for help and found some forum posts about entering the IO settings and changing the polarity by right clicking with "ctrl+alt+shift" and it didn't change anything.
I think I might have to fiddle with the driver wiring but that's where I am at a loss since I am afraid I will end up frying something.
Any ideas will be greatly appreciated.
Similar Threads:
-
- Need Help!- Changed NCStudio from 5.4.48 to 5.5.60 and now axis moves in the opposite direction
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules