Originally Posted by
CJHolcomb
I am new to Gerber, but I dove into a Sabre 404. Everything works on it but I don't have the software. I am trying to figure out if I should spend $1000 on the artpath or switch it over to mach3. I am generally mechanically inclined, but it was confusing to read this thread. With someone to walk me through the steps I know I could do it, but I am concerned about it being too big of a job.
Were any of you able to get one up and running on mach3? How much did it end up costing? Man hours and $$$.
Thank you for sharing your experiences.
Chris
Utah, USA.