Originally Posted by
mikeysp
Hi.
I just picked up a Gerber 408. I saw the colossal controller box and only being familiar with small stepper machines and mach3; I am unsure on how to proceed. It did not come with the software. I contacted Gerber to see what I need to do to get the software, but no response thus far. I will try again.
Will converting the machine to steppers have any negative effect on accuracy/speed?
Why convert to stepper rather than a servo controller like G320X DC Servo Motor Controller?
Since I have always looked at the more budget attainable machines with steppers and mach3, I am just at a loss as to what would be the wise direction to go.
Thank you for your advice.
-Mike