Where is the spindle? I,m in Brazil.
Via iPhone of the Tapatalk
Hi,
Wondering if anyone has experienced the noise I have with my HSD 929 spindle. I have just replaced it with a new shaft kit so the bearings should be fine. I did notice that with the old shaft that there was a similar sound at start up/warm up but then it would disappear. This leads me to think that there is an issue with the housing unit. The sound is quite tinny and sounds as if something is loose (at the 30 second mark of the video it seems to correct itself slightly) but I've refitted to make sure that all bolts are secure so there shouldn't be a problem there.
Any advice would be greatly appreciated.
Cheers
Similar Threads:
Last edited by branchy; 10-30-2014 at 02:43 AM.
Where is the spindle? I,m in Brazil.
Via iPhone of the Tapatalk
branchy
Do you have the correct amount of Grease in the Bearings, too much Grease can cause noise's at start up
Mactec54
that sharp noise at start,,,, little weird..
like a washer loose and getting up to the speed.. im not saying anything were loosen.. I just try to say an example..
by the way, what rpm it has on the video?
Mactec54
Hey mate,
Did you ever solve this issue? i have the same router (procam mityboy) and the exact same problem.
Any help would be appreciated,
Cheers,