- Need Help!- Tornado 300 Duplomatic Turret
-
Registered
Tornado 300 Duplomatic Turret
Hi,
We have a Colchester Tornado 300 with a 12 Tool Duplomatic Turret, with Fanuc O-T B.
It was running fine until last week.
The turret continued past it's designated tool, clicking as if the pin hadn't fired enough and flagged a "Turret overheat, turret unclamped, turret solenoid, 401 servo alarm"
We managed to get it going by backing off the solenoid capscrews, so the solenoid was sticking out by a few millimeteres. This got us away enough to complete the job.
We took the solenoid out and dismantled it, noticed that the insluation was a bit wet/slimey.
We've since replaced the solenoid with a brand new one, but are getting "1019 turret solenoid" errors.
If we back the solenoid off the turret rotates and locks in.
Is this a problem with the locking pin sensor?
Need this sorted asap, got a lot of work for this machine and can't wait for an engineer to "fit me in" in a few weeks time..... HELP!
Yarpo.
Similar Threads:
-
-
Registered
hi yarpo , you can try this.
Remove the round duplomatic cover from turret ,
in MDI mode command atool change ,
with the solenoid in place ,,
Using a screwdriver you must help the solenoid to lock in the right position , by pushing that locking pin
If you can do these several times then i will suspect you have a lack of voltage-current
from solenoid switching device ,
-
Registered
Thanks for the prompt reply cncatj..
I checked the voltage across the solenoid and I'm only getting 20volts, looks like this could be the problem.
Thanks again!
-
Registered
you have found the cause
Yarpo : How does your output pCB looks like ?
-
Registered
Traced the fault back to the PCB. IC-1. It is constantly outputting 24v.
IC-1 also operates the chuck, but that is working fine.
Looks like we'll have to de-solder IC-1 and try and replace it, or buy a new PCB (expensive option!)
-
Member
Re: Tornado 300 Duplomatic Turret
Hola tengo un torno Clausing Colchester STORM CNC 300, con fallas en el cambio de herramientas en la torreta DUPLOMATIC BSA200/ Series 20. Hace algunos cambios con pero después de 10 cambios de herramientas este falla, no bloquea la torreta. Ya seguí el procedimiento de ajuste pero aún a si sigue la falla la torreta tiene exceso de vibración al hacer el cambió, cuenta con 2 amortiguadores hidráulicos que no he cambiado, por qué no los encuentro. Me podrían apoyar un poco con esta falla?.
Saludos.
-
Member
Re: Tornado 300 Duplomatic Turret
Yo tengo el mismo problema, cambié los shock absorbe y ya me hace cambios, pero solo en un sentido, en sentido anti horario. Cuando regresa el giro en sentido horario me falla de nuevo.
Alguien me podrá ayudar?
-
Member
Re: Tornado 300 Duplomatic Turret
Check your sensors if they are OK I suspect you have a relay fault
- Need Help!- Tornado 300 Duplomatic Turret
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules