- Re Colchester 3000 L lathe Fanuc OT A control 910 911 alarm
-
Member
Re Colchester 3000 L lathe Fanuc OT A control 910 911 alarm
Hi recently bought Colchester 3000 L short bed Lathe Plugged in turned on Program displayed could not go to anything else x z key pad flashing alternately batt lift displayed. Shut down replaced batteries Then turned on and got 910 parity low Tried to reset then showed 911 parity high error Screen shows 600. 06 then goes to 910 alarm Tried turn ing on with delete Cancel buttons pressed just comes up with alarm error again can't get past error code display Bought secondhand main board installed,it but still same error . Anyone got any solution
Similar Threads:
-
-
Member
If you changed the batteries when the power was up there is a high probability that you have contaminated or lost your parameters and require reload
-
Member
Re: Re Colchester 3000 L lathe Fanuc OT A control 910 911 alarm
Hi yes that's right can't get past error parit high parity low 911 910 screen that is all it shows I was wondering if it alternates between high /low could the sdram be dodgy ?
-
Member
I'd clear all and reload where abouts are you ?
Please pm me for instructions how to reload
- Re Colchester 3000 L lathe Fanuc OT A control 910 911 alarm
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules