Vortex 4 flute "Tornado" Spiral. Are they worth the money?


Results 1 to 2 of 2

Thread: Vortex 4 flute "Tornado" Spiral. Are they worth the money?

  1. #1
    Registered
    Join Date
    May 2012
    Location
    USA
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Vortex 4 flute "Tornado" Spiral. Are they worth the money?

    I'm trying to get higher feedrates out of our cnc. We are mainly cutting hardwoods. I'm interested in the Vortex 4 flute "Tornado" downcut spiral bits. Is anyone using these? Are they worth the extra money? I am currently running 2 flute downspirals at 15000 rpm and 450 ipm. If I have my parts in a jig and I'm not worried about them moving, I've ran as high as 2000 ipm making cuts of 1/4" per pass. The vortex bits I mentioned are recommended to run at speeds no slower than 600 ipm. Just looking for some input here. What are you using? How fast are you cutting and how deep are you cutting?

    Similar Threads:


  2. #2
    Member camolover55's Avatar
    Join Date
    Nov 2020
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Re: Vortex 4 flute "Tornado" Spiral. Are they worth the money?

    I have used these bits to cut 3 sheets of 3/8" Plywood at once. I can run these bits a a very high Feed rate while still getting a perfect finish and They last a very long time. I am very happy with them and i personally think they are worth the cost



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Vortex 4 flute "Tornado" Spiral.  Are they worth the money?

Vortex 4 flute "Tornado" Spiral.  Are they worth the money?