- need help citizen M-32 LATHE ´´ OVER VOLTAGE´´ ERROR
-
Registered
need help citizen M-32 LATHE ´´ OVER VOLTAGE´´ ERROR
hi everyone
im victor,i new here
i have a citizen m-32 lathe and it has an ERROR
OVER VOLTAGE ERROR. the lathe sometimes work fine, but after 10 minutes the alarm appearrs again
help me please
-
-
Member
Re: need help citizen M-32 LATHE ´´ OVER VOLTAGE´´ ERROR
You have a short on the 24v dc this is normally the wire to the X2 brake clear any swarf from this area long term the cable will need attention
-
Member
Hello yes the power supply alarm is a problem on the drive you can send me a photo
- need help citizen M-32 LATHE ´´ OVER VOLTAGE´´ ERROR
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules