Need Help! Weeke BHC 550 - Disable Front Tool Changer


Results 1 to 1 of 1

Thread: Weeke BHC 550 - Disable Front Tool Changer

  1. #1
    Member HughDuffStephen's Avatar
    Join Date
    Aug 2022
    Posts
    1
    Downloads
    0
    Uploads
    0

    Default Weeke BHC 550 - Disable Front Tool Changer

    Hi, we have a Homag Weeke 550 with a front and rear tool changer (both 8 tool). But the motor on the front tool changer has burnt out, meaning the machine cannot run the reference routine (stops at SYNC M100). The KEB Invertor 2 also comes up with a error message (E.UP) as soon as the machine is turned on but I think this is related to the burnt out motor.
    Is anyone aware of a way of bypassing the front tool changer too allow us to have some functionality with the rear?

    Thanks for any advice,
    Hugh

    Similar Threads:
    Attached Thumbnails Attached Thumbnails Weeke BHC 550 -  Disable Front Tool Changer-img_20220803_124448-002-jpg   Weeke BHC 550 -  Disable Front Tool Changer-img_20220803_124454-jpg   Weeke BHC 550 -  Disable Front Tool Changer-img_20220803_124501-jpg  
    Last edited by HughDuffStephen; 08-03-2022 at 09:41 AM.


Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

Weeke BHC 550 -  Disable Front Tool Changer

Weeke BHC 550 -  Disable Front Tool Changer