Masterwood Project 323 (1993) Retrofit under Tecnos GA PLC (near MW309)

[leprovostgildas]

Hello,

i put a scheme of what i want to do :


I bougth a piece of card (Z80, CPU683 68EC020 PLC Tecnos system and input / output) for upgrade my cnc Master Project 323 who's working correctely with his old system under Dos ... but not very easy to use
These cards was working into a Masterwood Project 309 retrofitted

I replace old card (68000 named 681) by 683
and Z80 Si_89 by Si_96

I wonder if someone could help me to introduce good parameter to make it working ?

With some photos of retrofit of the Masterwood :

this new CPU3-2M CPU68EC020-2003-01 (31SFC104640) card

will replace the older CPU1 (68000) KTC91
new old

The old I/O cards (ACCTC90/02) will be replaced by new I/O cards 61SFA300101 (ASSI_CC_2007_01)


The communication interface Si2.5 is replaced too by SFS10150 SI_96_01 (31SFS101460)



and RamDisk Card is suppressed because no need anymore

the software MasterWork drive everything

To be followed,
Regards, GLP

Similar Threads:

• Masterwood Project 319-323
• Need Help!- Masterwood Retrofit
• Need Help!- Masterwood Project 313
• Need Help!- Control Retrofit for 1993 Fadal 6030
• Masterwood Project 416 K

[leprovostgildas]

Hello,
some pictures of what I want to do
is there anybody in the place who knows Tecnos controller ?

specialist of Masterwork parameters ?

Thanks, bye.

[Mice66]

The sw in the pic in the DOS version of machine HMI.
The firmware on 68000 card isn t compatible with the CPU 683, the SI2.5 could be compatible with both CPU.
The axes card can depend on the firmware too