It looks like the second one is carved deeper than the first; all the V-cuts are wider. Did Z change position from one to the other?
I am getting different results when changing the feed rate on my machine. When the feed rate is slower the engraving looks a lot better. Anyone know what would cause this?
When you look at the picture of the two "e"s the first "e" was done at a higher speed and the second "e" was done at a slower speed. So my question is what the hell would cause this? We replaced the bearing blocks on the X axis do we need to replace them on the Y axis too?
Similar Threads:
It looks like the second one is carved deeper than the first; all the V-cuts are wider. Did Z change position from one to the other?
[FONT=Verdana]Andrew Werby[/FONT]
[URL="http://www.computersculpture.com/"]Website[/URL]