Panelmac alarm code

[mobelsnickaren]

Hi. New here but have read a lot. We have been curious about the cnc world for a long time and recently happened to come across a better used scm tech 80. We read a lot in the manuals etc. But last Friday when we turned on the power and thought to start testing, there was a stop immediately. We were going to do a calibration but we did not succeed. The following message appears in the panel mac.

PLC5: Axes brushless fault drive
PLC: Machine emergency

We have checked all safety switches, ropes, doors etc. Does anyone know what that means?

Thanks in advance

Similar Threads:

• Need Help - Amada RG 80 Error code 315 / Alarm code 315
• alarm 408 servo alarm "serial not RDY", αP18 fanuc mtor code
• Need Help!- Can I tell how many linear feet a bit has cut? Morbidelli 636 and PanelMAC
• Problem- xilog e panelmac con masterwood310
• HELP QT 350 alarm code 371 turret servo alarm

[mobelsnickaren]

Now we have managed to get past and calibrate the machine. But when we were to run a test, it hung in the tool switch instead. So now we are wondering instead if anyone knows how to force the machine to some kind of origin. We did not have a holder in the spider. and guess that's what triggered a stop instead.

I'm just waffling here. But if anyone knows, we would be happy.

thanks

[mobelsnickaren]

I jerked past the safety loop. Then I managed to move the machine and close the magazine via MDI. And hoped it would remove my error message. But that was not the case. But I failed to make a tool change via MDI. Don't get wise to this.

PLC76
And again, the following has also emerged. It is these codes that I removed earlier.
PLC4
PLC5

[dmitry83]

it could be that tool changer is still opened or main spindle is not in up position

[aleksmeraz]

I jerked past the safety loop. Then I managed to move the machine and close the magazine via MDI. And hoped it would remove my error message. But that was not the case. But I failed to make a tool change via MDI. Don't get wise to this.

PLC76
And again, the following has also emerged. It is these codes that I removed earlier.
PLC4
PLC5

Hello, I just have the same problem, did you already solve it?
Do you know how can I get pass thru the "emergency stop"?

[AASD]

Hello, I’m using SCM tech z5 cnc. I have a problem my machine is not moving can you help me? I got a plc4 code pls help me with this.